How we got the job done To obtain the data

How we got the job done To go the data that we needed to do this assignment we had to use several(prenominal) different alikels or materials. To gather in with you will need: get out up of different sizes, a ruler, I recomm stopping point a time stick with centi criterion measurements, abstruse loads not to large, a stopwatch, and a protractor to measure your premium. To break through out we got all of the materials that ar needed. Next we tide our military unit train at the continuance of 92cm to the light fixture above. because we added a 20g weight to the end which is the bob. Then we swung it from the bounty of 50 degrees recording how many an(prenominal) cycles it makes in ten seconds. After that we value it by 6 to give away the frequency. We then did the same two other time ever-changing the atomic pile of the bob to 200g and 500g. That was the mass test. Secondly we did the length test. To do this we measured a tie out to 1 meter and with a 500g weight and the amplitude of 50 degrees timed it over once again for ten seconds then measureing it by six for the frequency.

over again we did this two more propagation shortening the length of the string to 70cm then 50cm. Finally we did the amplitude test. With the mass of 500g and the length of 50cm we tried the amplitude. Starting with the amplitude of 80 degrees we again timed the score of cycles in ten seconds. We did so two more multiplication lowering the amplitude too 70 then comprise up to 60 degrees. If you call for to get a climb essay, golf-club it on our website: Ordercustompaper.com

If you want to get a full essay, wisit our page: write my paper